ROUSH IS A REGISTERED TRADEMARK OF ROUSH ENTERPRISES, INC. SALEEN IS A REGISTERED TRADEMARK OF SALEEN INCORPORATED. CUMMINS IS A REGISTERED TRADEMARK OF CUMMINS INC. ALLISON TRANSMISSION IS A REGISTERED TRADEMARK OF ALLISON TRANSMISSION, INC. DODGE, DODGE RAM, RAM TRUCKS, RAM 1500, RAM 2500, RAM 3500, SRT/10, 1500 SLT PLUS, 1500 SLT, ST, LARAMIE, DAYTONA, MEGA CAB, SLT/SPORT/TRX, SLT/TRX, R/T, SPORT, LARAMIE LONGHORN, TRADESMAN HEAVY DUTY, TRADESMAN/EXPRESS, TRADESMAN, HFE, REBEL, LONGHORN ARE REGISTERED TRADEMARKS OF FIAT CHRYSLER AUTOMOBILES (FCA). ECOBOOST, CHEVROLET, GMC, CHEVROLET SILVERADO, GMC SIERRA, SILVERADO, SIERRA,DENALI,VORTEC LS V8, DURAMAX, LTZ, SILVERADO LT, SILVERADO HD, SIERRA ALL TERRAIN X, ECOTEC3, Z-71, SILVERADO 1500, AND SILVERADO SS ARE REGISTERED TRADEMARKS OF GENERAL MOTORS COMPANY (GM). Truck Light Switches, Wiring & AccessoriesįORD, FORD F-150 & F-150, FORD F-250 & F-250, FORD F-350 & F-350, FORD RANGER, FORD LIGHTNING, SUPERCREW, SUPERCAB, POWER STROKE, TRITON V8, ECOBOOST, SUPERDUTY, ARE REGISTERED TRADEMARKS OF THE FORD MOTOR COMPANY.Truck Radiators, Intercoolers, and Accessories.If you wish, remove decals prior to installation of flares. G) Decals: Flares may interfere with existing decals on vehicle. Spray inner fender wells with undercoating AFTER flare attachments have been completed. (Exhaust gases should not vent directly onto flares)į) Metal Protection: All exposed fasteners and bare metal should be treated with rust resistant paint BEFORE installing flares. Some Tire/Rim combinations may require lowering bump stops and or installing steering stops to prevent tire from contacting flare.Į) Exhaust System: Modifications may be necessary to maintain a minimum 4" clearance between flares and exhaust pipes. If painting edge trim (not recommended), use a flex additive.ĭ) Performance: Using larger Tires may increase the area required to turn the vehicle. Paint flares using a high quality enamel, or polyurethane automotive paint. Application of plastic adhesion promoter for ABS plastic as per your paint system manufacturer's recommendations is required. Wipe outer surface thoroughly with a tack rag prior to paint. DO NOT USE LACQUER THINNER OR ENAMEL REDUCER AS A DEGREASER. Clean outer surface with a good grade degreaser. (Some filing, sanding, or cutting may be necessary to ensure proper fit).Ĭ) Painting: (Optional) if paint is desired it must be done prior to installing flares on vehicle. DO NOT USE: Loctite, SuperGlue, or similar products on the hardware or the flares.ī) Fit: Verify the fit of the flares to vehicle. This includes, but is not limited to using alternative installation methods, hardware, or materials.
BUSHWACKER FENDER FLARES INSTALLATION VIDEO INSTALL
WARNING: Failure to install according to these instructions will invalidate the warranty. A) Bushwacker only approves installing the flares according to these written instructions with the hardware provided.